1·Downlights can be divided into 2 inches, 2.5 inches, 3 inches, 4 inches, 5 inches, 6 inches, 8 inches, and 10 inches according to their size. Generally, there are three parameters related to size: outer diameter, hole size, and thickness. That is, the size of the hole dug during ceiling construction
2·According to the classification of the lamp beads used in downlights, they can be divided into three types: high-power lamp beads, low-power lamp beads, and integrated lamp beads. Among them, high-power can be divided into 1W, 2W, and 3W single beads. The chips and packages of good suppliers can make the lamp beads reach 5W and 10W power; low-power can be divided into 3014, 3528, 5050, etc. according to the packaging form; integrated lamp beads, namely COB. From the appearance and heat dissipation, in theory, low-power lamp beads have fewer light spots and relatively better heat dissipation, and are increasingly popular with customers.
3. Downlights are usually matte, but the matte surface is at the expense of reduced light efficiency, so some downlights are also made into transparent covers
Introduction to LED packaging technology
1. Crystal expansion, open up the densely arranged chips a little to facilitate crystal bonding.
2. Crystal bonding, apply conductive/non-conductive glue to the bottom of the bracket (conductive or not depends on whether the chip is a top-bottom PN junction or a left-right PN junction) and then put the chip into the bracket.
3. Short baking, so that the chip does not move when the glue is solidified and the wire is bonded.
4. Wire bonding, use gold wire to connect the chip and the bracket.
5. Pre-test, preliminary test whether it can light up.
6. Glue filling, wrap the chip and the bracket with glue.
7. Long baking, let the glue solidify.
8. Post-test, test whether it can light up and whether the electrical parameters meet the standards.
9. Spectrophotometry and color separation, separate products with roughly the same color and voltage.
10, packaging.